This One For All universal remote is compatible with nearly all the media centers in your residence. Similar to any other remote that needs to be programmed for control of the device, One For Universal remote is the one that needs to be programmed to connect to your TV and other media devices. Here are some simple programming with One For All universal remote codes. We have also included one for all remote search method So, take a look at them and try your codes until you are able to program your device.
How to program One Universal Remote for All Without Coding
With the auto-search method, all one for all universal codes go through a scanning process within the remote. It scans a single code at a time in order to identify the correct remote code that will work with your remote to set up the remote control. Follow the steps below:
“Switch on” the smart device such as “TV” that you’d like to use as a universal remote with.
“Turn on” the remote, press the button for the device (TV DVD, CBL, OK/SEL) for 3 seconds. The LED light will indicate that the device is prepared to be programmed.
Point out the remote to the device and then click on “CH+” & “CH+” switches. Remote will show off and on signals. Press the “up” or “down” key repeatedly until the device will be turned off.
Check the code by pressing on the “power” key. The device will be turned on. If it starts, try to change the channel to confirm that the remote has been properly programmed.
Tap then the “device” button to save the code. The LED on the device will flash twice to confirm the code saved.
How to program One for allUniversal Remote Manual Method
Utilizing the keycode, you can easily create a universal remote, and the keycode will identify the manufacturer and model of your device.
You must first “Turn the device on”
Click “TV” on your “One For All universal remote”
Then press while holding on the “Setup button” of the Universal Remote until it displays “Light Flash” (It show it’s”Learning mode”)
Enter your “Keycode” which you gathered from the above table.
After you’ve completed the procedure, just “point the remote towards the television” and then “Press and Hold the Power” button.
You can release the “Power Button” whenever the screen is turned off.
This is it, your television will now function perfectly using this universal remote. In case your device isn’t working, try repeating the same process using the different code that is in the same area of the table referenced.
How to program One for all universal remotes withthe Code Search
If you are unable to locate the code that works on the device at the moment, you can change your universal remote in search mode to find the right one. This is a manual code that forces the remote to enter the search mode.
First , “Turn The Device On”
Then press then hold “Setup” button
You must enter into the “9-9-1” (three digit) code.
Then hold down the “Power Button” on the remote. Then press the Channel up until your TV “Turns off”
The above procedure may require long time, however it is crucial to identify your code. After you’ve completed the above steps, your remote should function perfectly.
